The Rich Solar RS-PC100 is a 100 amp power converter and battery charger designed to supply 12-volt direct current power and charge compatible batteries from a 120-volt alternating current source. It provides up to 100A continuous output and 1,460W maximum continuous power output for properly installed vehicle or device electrical systems. Selectable lithium and lead-acid battery charging modes let the converter follow documented charging profiles for the chosen battery type. Built-in reverse polarity, overload, and thermal protection support safer operation when installed and used according to the manual. The manufacturer requires certified electrician installation, proper wiring, ventilation clearance, and a protected interior mounting location out of direct weather.
The RS-PC100 is specified with approximate no-load direct current output voltages of 14.6V, 13.6V, and 13.2V, with up to 100A continuous output and 1,460W continuous power output. These ratings make it a practical converter-charger option for compatible 12V electrical systems requiring a defined high-amperage charging source.
A battery-type selector allows the converter to be set for lithium batteries or lead-acid batteries. The manual documents a two-stage lithium charging profile using 14.6V boost and 13.6V normal operation, while lead-acid mode uses 14.6V boost, 13.6V normal, and 13.2V storage stages.
Rich Solar lists reverse polarity, overload, and thermal protection for the RS-PC100, along with proportional fan control. The manual states that the cooling fan runs as needed based on temperature rather than operating continuously, supporting practical thermal management during use.
The converter requires a 120 VAC receptacle within 36" of the unit and installation near the batteries and 12 VDC distribution panel where appropriate. Rich Solar specifies an interior mounting surface out of direct weather, at least 1" of free air space at each end for cooling, minimum 8 AWG copper wire for the stated bonding-lug and 12 VDC wiring connections, and installation by a certified electrician.
The RS-PC100 delivers up to 100A continuous direct current output for properly installed compatible 12V charging and power-conversion applications.
Select the documented lithium or lead-acid charging mode for the connected battery type, then follow Rich Solar wiring and ventilation instructions during installation.
Need help selecting the right converter charger for your battery system?
Contact TrueStead Supply for charger selection guidance, battery-system comparison support, and quote assistance.
✔ Charger selection guidance ✔ Battery system support ✔ Quote assistance
Contact Us for a Quote| Brand | Rich Solar |
| Model / SKU | RS-PC100 |
| Product Type | Power Converter / Battery Charger |
| AC Input Source | 120 VAC receptacle required |
| DC Output Voltage, No Load | Approximately 14.6V / 13.6V / 13.2V |
| Maximum Continuous Output | 100A |
| Maximum Continuous Power Output | 1,460W |
| Maximum AC Current | 15A |
| Typical Efficiency | Greater than 85% |
| Charging Modes | Lithium battery mode and lead-acid battery mode |
| Lithium Charging Profile | Two-stage: 14.6V boost mode and 13.6V normal mode |
| Lead-Acid Charging Profile | Three-stage: 14.6V boost, 13.6V normal, and 13.2V storage modes |
| Fan Control | Proportional; temperature controlled and operates when needed |
| Protection Functions | Reverse polarity, overload, and thermal protection |
| Mounting Location | Interior mounting surface, out of direct weather |
| Ventilation Clearance | Minimum 1" free air space at each end of the unit |
| Electrical Installation | Certified electrician installation required per manufacturer manual |
| Certification Document | Intertek Certificate of Compliance lists RS-PC100 to UL 458 and CSA C22.2 No. 107.1 standards |
